William (Roscoe) Tomlin is
in the process of a P35 make-over.
In this section he is concentrating on keeping the bilge dry.
Look at the size of that
pump. Last update
11/24/2006
The small pump
is mounted in the forward port side of the center board tunnel 2" off
bottom. The larger pump is mounted 1" off the bottom and at the end of
the center board tunnel. The top of the longest mount is screwed to
the front of the engine mounting trough then a 1/4" brass bolt goes
through the center. all that is visible of this pump is the screws
and bolt that holds it in place.
