"

0001 All boards was rough cut teak and needed milling to acceptable size.
0006 First lay-up numbers was to keep boards in order for biscuit installation
0007 By cutting boards together insures length.
0008 thru bolt holes insure uniformity
0009 Ends rough sanded on long end" right in photo" Short boards on left being used as spacers.
0011 All boards receive Biscuits on 12 inch centers alternating from the end at 6 and 12 inches.
0012 Forward end with thru bolt hole, rough sanded.
0016 Starboard side fitted and glued.
0023 Starboard and port side with glue biscuits and clamps.
0025 Board for windless mount ,cross grain
0027 with board out of clamps the first sanding is compleated.0029 Edges rounded to control splentering.
0034 Carriage bolt for thru-bolting showing nut and countersink, a teak plug will later be turned and glued to fill hole.
0039 Finished and ready for accessories.

010001 Layout of windlass on cross grain mounting pad.
010003Holes cut and sealed
010009 checking windlass fit.
0004 aft end of sprint router for cutter rig anchor.
00006checking fit of 1/3X2 inch stainless for fit
000014 Checking chain plate for fit before welding
00082 out with the old
000083 Next make some holes
00089 This shows the old sprint at the top with forestay anchor mount being duplicated on new sprint with protractor, square, chisels, mallet, and rasps.
000091 forestay anchor in place and sealed and bolted.
00094 accessories in place sealed and bolted.
000098Switch holes drilled 00099Water proof switches sealed and mounted
Total boatbuck cost about 25 emphasis on about"

- Roscoe